Tews TPMC810Fieldbus: Isolated 2x CAN bus
| Tews TPMC810 |  | |
|---|---|---|
| pmc | powerpc | v. 4.0 |
| Market: | military and aerospace | |
The TPMC810 is a standard single-width 32 bit PMC with two independent CAN bus channels, isolated from system logic and from each other. Two Philips SJA1000 CAN controllers (CAN specification 2.0B supported) are used.
CAN High Speed transceivers are used for the CAN bus I/O interface. An on-board termination option (DIP switch) is provided for each CAN bus channel to configure on-board termination and pass through mode for the CAN bus.
Each channel can generate an interrupt on INTA.
The TPMC810 provides front panel I/O via two DB9 male connectors and rear panel I/O via P14.
View more Tews boards, or learn more about Tews Technologies, a SynergyWorks partner.
A LynuxWorks embedded OS is featured in this embedded system application:
Who else uses a LynuxWorks embedded operating system?
Boards for all LynuxWorks operating systems
Boards for 
Device drivers
- ARM processor boards
- PowerPC processor boards
- x86 / IA-32 processor boards
- MicroBlaze processor boards
- MIPS processor boards
- All boards
- ARM processor boards
- PowerPC processor boards
- x86 / IA-32 processor boards
- MicroBlaze processor boards
- MIPS processor boards
- All boards
- ARM processor boards
- PowerPC processor boards
- x86 / IA-32 processor boards
- MicroBlaze processor boards
- MIPS processor boards
- All boards
Boards for
Device drivers
Virtualization / RTOS News
- ARM Processor Support for LynxOS-SE RTOS Builds Secure Mobile Applications -7/13
- Keeping Embedded Software safe and Secure in an Unsafe World -6/10
- Consumer Trends Fuel Medical Device Innovation -4/10
- Announcing LynxSecure 4.0: the most Feature-Rich Secure Separation Kernel and Embedded Hypervisor -4/27/10
EVENTS
- LynxSecure Real-time Applications and Device Driver Programming Workshop, San José, CA, USA, Jul 27-30
- UCDMO (Annual Unified Cross Domain Management Office), Boston, MA, USA, Aug 9-12
- AUVSI Unmanned Systems North America, Denver, CO, USA, Aug 24-27
