Tews TPMC806Conduction-cooled PMC module with CAN bus and MIC bus interface

Tews TPMC806
pmc	powerpc	v. 4.0

Tews' TPMC806 is a conduction-cooled single-width 32-bit PMC module providing two channels of high-speed CAN bus interface and a MIC bus interface.

This product requires an export license for certain countries!

The PLX PCI9030 PCI target chip is used for the PCI interface.

Two Philips SJA1000 CAN controllers (CAN specification 2.0B supported) are used for the two CAN bus channels.

The CAN bus I/O interface provides two independent channels, isolated from system logic, from the MIC bus interface and from each other.

CAN high-speed transceivers are used for the CAN bus I/O interface. An onboard termination option (solder pads) is provided for each CAN bus channel allowing to configure onboard termination and pass-through mode for the CAN bus.

A Vetronix MIC320GM MIC bus controller is used for the MIC bus interface.

The MIC bus I/O interface provides two channels isolated from the system logic and from the CAN bus interface.

ESD protected high-speed RS485 transceivers are used for each MIC bus channel. An onboard termination option (solder pads) is provided for each MIC bus channel allowing to configure onboard termination and pass-through mode for the MIC bus.

The TPMC806 uses the P14 I/O connector for the CAN bus and MIC bus I/O interface.

Two versions of the TPMC806 are available: the TPMC80610 with a standard front panel allows using the board in standard PMC slots and the TPMC806-11 which has no front panel for use in conduction-cooled PMC slots.

View more Tews boards, or learn more about Tews Technologies, a SynergyWorks partner.