Tews TIP845IndustryPack 48-channel 14-bit analog-to-digital conversion

Tews TIP845
ip	powerpc	v. 4.0

Tews' TIP845 is an IndustryPack®-compatible module providing 48 single-ended or 24 differential ADC input channels. The data acquisition and conversion time is up to 2.5µs without channel / gain change and up to 9µs with channel / gain change. The resolution is 14 bit.

The input multiplexer of the A/D circuit offers analog overvoltage protection of up to 70Vpp. A programmable gain amplifier allows gains of 1, 2, 4 or 8 resulting in input voltage ranges of +/-10V, +/-5V, +/-2.5V or +/-1.25V.

Additionally the TIP845 provides a sequencer to control the analog inputs without wasting CPU time. Each of the A/D channels can be independently enabled and configured by a sequencer instruction RAM. After the last instruction of a programmed sequence has completed, the ADC data of all enabled channels are stored in the data RAM. The repeat frequency of the sequencer can be programmed by using the sequence timer. The sequence timer is programmable from 100µs to 6.5535s in steps of 100µs. Whenever the timer reaches the programmed value the sequencer starts a new sequence. A special function is the sequencer continuous mode. It is activated by setting the sequence timer register to 0. In this mode the sequencer will start again with the first instruction of the sequence as soon as the last instruction of the previous sequence has been completed.

An interrupt can be generated at end-of-settling, end-of-conversion or end-of-sequencer cycle supporting an 8-bit vector.

Each TIP845 is factory-calibrated. The calibration information is stored in the Identification-PROM unique to each IP.

View more Tews boards, or learn more about Tews Technologies, a SynergyWorks partner.