Curtiss-Wright SVME/DMV-179: PowerPC single-board computer (SBC)

Curtiss-Wright SVME/DMV-179
PowerPC single-board computer (SBC)

Curtiss-Wright SVME/DMV-179
	v. 3.11 (hardware-vendor BSP)
Architecture:	PowerPC
Processor group:	Freescale MPC74xx
Market:	military and aerospace
Please consult the board-support guide or contact us for specific platform features supported.

The Curtiss-Wright (formerly DY 4) SVME/DMV-179 introduces a fully 64-bit architecture, a ground-breaking 48 Mbytes of direct memory-mapped, 64-bit wide Flash and 400 MHz performance, all at a low power dissipation of only 17 Watts (typical).

Providing high-performance synchronous DRAM combined with the high system integrity of Error Checking and Correcting (ECC), the SVME/DMV-179 is ready for the challenges of avionics, tactical ground vehicle, and rugged naval applications.

PowerPC® 750 or 7400 (AltiVec Technology™-enhanced) CPU
64, 128, or 256 Mbytes Synchronous DRAM with ECC without mezzanines
1 Mbyte (with 750 CPU) or 2 Mbytes (with 7400 CPU) of L2 cache
Peak processor-memory bandwidth of 528 Mbytes/sec; peak L2 cache bandwidth of 1.064 Gbytes/sec
Up to 48 Mbytes of 64-bit wide direct memory-mapped Flash memory
32 Kbytes of AutoStore nvSRAM
512 bytes of Serial EEPROM
Two IEEE P1386/1386.1 64-bit, 33 MHz PMC sites for high-performance I/O expansion
64-bit PCI local bus architecture, 264 Mbytes/sec peak data transfer rate
10/100BaseTX (twisted pair) Ethernet™ port
8 or 16-bit Ultra SCSI interface
Two EIA-232 serial ports
Two HDLC/SDLC-capable EIA-422/485 serial channels, one with DMA support
12 bits of discrete TTL I/O, each with interrupt capability
One 32-bit, three 24-bit general purpose timers
Three 16-bit system timers
Watchdog timer with software programmable time-out period
Real-time clock with automatic +5 V/+5 V STDBY switchover
Four general-purpose PCI DMA controllers
Tundra Universe II™ VME64 master/slave interface
Comprehensive foundation firmware with: debug monitor and non-volatile memory programmer; suite of card support service routines; BIT firmware with 95% BIT fault coverage
LynxOS® reference port
Occupies single .8" slot in all configurations
Base card uses +5 V only, backplane 3.3 V, 5 V and ±12 V are routed to the PMC sites
Supported by a dedicated staff of factory-based product support specialists and a network of regional field application engineers
Available in a range of ruggedization levels, both air- and conduction-cooled.